φ3.2 (special order item)
φ4.8 (standard item)
Stain mesh
(Order accepted per 5 mm, from 65 mm to 100 mm)
60 (standard item)
Cable length; 2000mm (standard item)
9. G sensor (* The G sensor is an optional part.)
１． Use two-sided tape to attach the sensor onto a location that is level in the
front/back and left/right direction. Attach so that the front of the sensor points in
the direction of forward travel. In order to fasten the sensor securely in place, use
M4 screws, tying bands, or covering the sensor by vinyl tape. * The M4 screws
and tying bands are not provided.
２． Refer to "Selecting the Data Item to Display During Driving" and verify the
front/rear and left/right G values. Even if the value shown on the display monitor
deviates slightly from 0.00, this will be corrected during driving. (The value at time
of shipment is 0.00 – 0.04.)
<If malfunction occurs when installed onto a racing kart or similar vehicle>
If the sensor is subjected to strong vibration, malfunction may occur. Place
low-repulsion urethane (sponge or similar) around the sensor to absorb vibration.
-15-
To Next Page
Loading...