Percul Lapcom S Separate 100 - No. 10 & 11: Temperature Alarm

No. 10 (TEMP1) & 11 (TEMP2): Temperature Alarm
* Press the CLEAR key and display parameter No. 10/11.
10┘┘┘ TEMP1 upper limit alarm setting (Default value: 000; alarm disabled)
When the temperature exceeds the set value, ℃ flashes and the orange LED on the
right side illuminates.
１． The ┘┘┘ (upper limit mark) or ┐┐┐(lower limit mark) on the right side of the
parameter No. flashes. Press the SET key and select ┘┘┘(upper limit mark).
２． Press the SHIFT key and move the flashing part to the temperature display, then
press the SET key and enter a number.
３． To set the TEMP 1 lower limit alarm, press the SHIFT key and move the flashing
part to the right side of the parameter No.
４．
Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Parameter No. Temperature
-34-