the connector.
7. Spark plug temperature sensor (* The spark plug temperature sensor is an optional part.)
1. Remove the spark plug and ring.
2. Confirm if the sensor ring fits in the spark plug. Fit the sensor ring in the spark plug.
3. Place back the spark plug on the cylinder head and tighten the spark plug.
4. Make a hole in a cooling fin and fix the sensor spring through the hole. See the
picture below.
5. Insert the spark plug temp. sensor connector into the TEMP sensor jack of the
control unit.
-14-
Fasten the senso
to the cooling fin.
8. Intake/exhaust air temperature sensor (* The intake/exhaust air temperature sensor is an
optional part.
)
１． Make a hole in the exhaust pipe. Weld a 1/8PT nut that should be the same metal
with the exhaust pipe. The nut for welding isn’t provided in the sensor kit. Please
provide the nut as per your exhaust requirement.
２．Mount the attached longer nut in the welded nut.
３．Mount the sensor and the attached shorter nut into the longer nut and adjust the
length of the sensor head.
４．Fasten the shorter nut to fix the sensor head.
To Next Page
Loading...