※ If km/h is set, the temperature display is automatically changed to centigrade
display. If m/h is set, the temperature display is automatically set to Fahrenheit
display.
Km/h
Parameter No.
Units of speed
No. 7: Logging start/stop condition
* In order to perform logging, measurement of wheel speed and lap time is
required.
* Press the CLEAR key and display parameter No. 7.
7－－－: Without Memory card (Measurement and display only)
The memory card is not necessary and logging will not be performed.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter a hyphen.
２． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
-27-
To Next Page
Loading...