Percul Lapcom S Separate 100 - No.9: Information Lamp and Bar-Graph Full Scale

No. 9: Information lamp and bar-graph full scale
The RPM warning lamp setting can be set for each LED from 9－－1 to 5. When the
RPM exceeds the set value, the corresponding LED illuminates.
* Press the CLEAR key and display parameter No. 9.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter the LED number to set. For the numbers, refer to
the figure below.
２．
Press the SHIFT key and move the flashing part to the RPM display. Press the
SET key and enter values.
３． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
-33-
* If the engine speed for 9--5 (LED: red) is set higher than 12,000 rpm, the bar graph scale is automatically
changed from 12,000 rpm display to 23,000 rpm display.
Parameter No.
RPM
9--5 Red
9--4 Red
9--3 Orange
9--2 Green
9--1 Green
12,000 rpm scale 23,000rpm scale