Percul Lapcom S Separate 100 - No.6: Unit of Speed

5－－1: Using Speed sensor
Set as follows when a speed sensor is used to measure the wheel speed.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter 1.
２．
Press the SHIFT key and move the flashing digit to the speed pulse length, then
press the SET key and enter a number. Enter the value of the measured tire
circumference divided by the number of sensor detection triggers as the vehicle
speed pulse length.
Speed pulse length = Measured tire circumference ÷ Number of installed magnet triggers
* If the wheel speed signal is acquired from the ECU, refer to the separate provided
materials.
３． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Parameter No.
Speed pulse length
No. 6: Units of Speed
Select km/h or m/h (miles) as the units for wheel speed display.
* Press the CLEAR key and display parameter No. 6.
１． The speed units display flashes. Press the SET key and select the units.
-26-
２．Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.