Percul Lapcom S Separate 100 - No. 5: Speed Pulse Length

No. 5: Speed Pulse Length
5－－－: Without speed sensor; engine directly connected to drive shaft
In a vehicle such as a racing kart where the engine is connected directly to the drive
shaft without a clutch, the wheel speed is calculated from the RPM.
* Press the CLEAR key and display parameter No. 5.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter a hyphen.
２． Press the SHIFT key and move the flashing digit to the circumference of the
drive tires, then press the SET key and enter a number.
３． In the same way, enter the number of sprocket teeth on the drive side and the
number of sprocket teeth on the driven side.
４． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Number of sprocke
t
teeth on the driven side
Number of sprocke
t
teeth on the drive side
Circumference of drive tires
Parameter No.
Terminal plug
If the speed is acquired
from the plug cord,
depending on the signal
strength, the signal may
have an effect on the
speed port. If a speed
sensor will not be used, be
sure to install the provided
terminal plug.
-25-