No. 4: Sensor off timer [Default value: 001]
This setting stops the sensor function for the setting period after a beacon is detected.
A sensor off time can be set for example when you will measure only the lap time in
order to disable the sensor function after the lap beacon is detected.
* Press the CLEAR key and display parameter No. 4.
１． To the right of the “SEC” indication, the 3-digit time setting value flashes. The
value changes each time the SET key is pressed. Press the SHIFT key to change
the digit, then use the SET key to enter the value. Values are set in 1 second
increments, with a maximum value of 599 seconds.
２．
Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
* For ordinary driving, use the default setting of 001.
* If the set time is longer than the lap time, lap time measurement will not be possible.
Parameter No.
To Next Page
Loading...