Percul Lapcom S Separate 100 - Transferring Parameters from Memory Card

Display PP--1 and
finish the setting by
pressing and holding
for 3 seconds then
go back to [READY]
display.
CLEAR key
SET
キ
ー
SHIFT
キ
ー
The display of PP--1
and PP--2 changes
each time the key is
pressed.
SET key
SHIFT
キ
ー
Press and hold for 3
seconds, then a
parameter will be
transferred from the
main unit to a
memory card, o
r
from a memory card
to the main unit.
SHIFT key
PP--1 or PP--2
will display
<Transferring the parameters on a memory card to the main unit>
１． Verify that [READY] is displayed on the display screen. If [READY] is not
displayed, press the CLEAR key to display it.
２． Insert the memory card into the main unit.
３． Press and hold switch 1, the SHIFT key, and the MODE key at the same time for
3 seconds. The screen changes to the parameter selection screen, and either
PP--1 or PP--2 is displayed.
４． Press the SET key and display PP--2.
５． Press and hold the SHIFT key for 3 seconds. The display turns off for an instant,
and the parameters on the memory card are transferred to the main unit memory.
６． Press the SET key and display PP--1.
７． Verify that PP--1 is displayed, then press and hold the CLEAR key for 3 seconds.
The screen returns to the initial screen, and [READY] is displayed.
-50-