Percul Lapcom S Separate 100 - No.17: Logging Interval

No. 17: Logging interval
The logging interval can be selected.
* Press the CLEAR key and display parameter No. 17.
１． The logging interval display flashes. Press the SET key and select one of the
following: S (0.1 second interval), M (0.2 second interval), L (0.5 second interval),
or off (0.05 second interval).
※ Ordinarily, only the S setting should be used.
※ Off (0.05 second interval) is available only on the S ALL 100 PLUS, S LITE 100
PLUS, and S SEPA 100 PLUS models.
２． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Parameter No.
Logging interval
-43-