16－－2: Enter the gear ratios.
If accurate information is available concerning the primary reduction gear ratio,
secondary reduction gear ratio, and gear ratio for each gear of the vehicle, directly
enter the gear ratio for each gear No.
※ If the vehicle speed is acquired from any wheel other than a drive wheel, the
correct gears will not be displayed.
※ The total number of gears and pulse count are set in 16--1.
※ The settings for 16--1 and 16--2 are linked and the parameter information is
shared between them. If the gear ratio is changed in either setting, the change is
applied to both.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter 2.
２．
Press the SHIFT key and move the flashing part to the gear ratio display.
Calculate the 1st gear final reduction ratio from the primary reduction gear ratio,
secondary reduction gear ratio, and gear ratio of each gear for the vehicle. Press
the SET key and enter the number.
３．
Press the SHIFT key and move the flashing part to the gear No. display. For 1st
gear, press the SET key and enter "1" for the gear No.
Gear ratio
Gear No.
Parameter No.
-42-
To Next Page
Loading...