Percul Lapcom S Separate 100 - No. 8: REV Position (Engine Type)

No. 8: REV position
Set the engine type.
* Press the CLEAR key and display parameter No. 8.
１． The tachometer position display flashes. Press the SET key and select the
tachometer position. Refer to the list below.
２． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
※
In rare cases, the parameter listed below may not be suitable. In that case,
change the value to the suitable configuration for your engine.
P: 1 4-stroke 1-cylinder
P: 2 2-stroke
4-stroke
1-cylinder
2-cylinder
P: 3 4-stroke 3-cylinder
P: 4 2-stroke
4-stroke
2-cylinder
4-cylinder
P: 6 2-stroke
4-stroke
3-cylinder
6-cylinder
P: 8 4-stroke 8-cylinder
P: 10 4-stroke 10-cylinder
P: 12 4-stroke 12-cylinder
Parameter No.
Tachometer position
-32-