7－－3: Logging all data from engine start to engine stop
※ A SD memory card is required.
※ Be aware that logging will not be started if the RPM signal is not acquired.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter 3.
２．
Press the SHIFT key and move the flashing part to the RPM display, then press
the SET key and enter a number. When the set RPM is reached, logging is
started. When the RPM drops below the set value, logging is automatically
stopped.
３． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
RPM setting
Parameter No.
* Do not turn off the power without stopping the logging. The logging data will be
damaged.
* To stop logging manually, press the CLEAR key.
* To automatically stop logging sooner when returning to the pit, set a higher
RPM.
* Be sure to stop logging when entering the pit.
-31-
To Next Page
Loading...