Percul Lapcom S Separate 100 - No. 12 & 13: Pressure Alarm

10┐┐┐ TEMP1 lower limit alarm setting (Default value: 000; alarm disabled)
When the temperature drops below the set value, ℃ flashes and the orange LED on
the left side illuminates.
１． The ┘┘┘ (upper limit mark) or ┐┐┐(lower limit mark) on the right side of the
parameter No. flashes. Press the SET key and select ┐┐┐(lower limit mark).
２． Press the SHIFT key and move the flashing part to the temperature display, then
press the SET key and enter a number.
３． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Parameter No.
Temperature
In the same way, set the No. 11 (TEMP2) temperature upper limit and lower limit alarms.
No. 12 (Press1) & 13 (Press2): Pressure Alarm
* These settings are used for pressure measurement. This function cannot be used
with S All & S Lite.
-35-