7－－1: Perform logging only of laps where lap time is completed. (Default value: 20 km/h,
599 seconds)
The out-lap and in-lap are not measured.
Only the completed laptime data will be logged.
※ A SD memory card is required.
※ Speed measurement is required. Be aware that logging is not possible if the
speed is not measured.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter 1.
２．
Press the SHIFT key and move the flashing part to the wheel speed display, then
press the SET key and enter a number. When the set speed is reached,
preparation for logging is started. After the vehicle detects the first lap beacon,
logging starts.
３．
Next, press the SHIFT key and move the flashing part to the time display, then
press the SET key and enter a number. Logging is automatically stopped when
the length of time set here has passed after the wheel speed drops below the
speed setting in 2.
４． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Time setting
Wheel speed setting
Parameter No.
Km/h
<Example of the above setting>
When the wheel speed exceeds 20 km/h after the vehicle leaves the pit, and the first
lap beacon is detected, the logging is started.
-28-
After repeated laps, when the vehicle enters the pit road, the speed falls below 20 km/h,
and then 599 seconds have passed, logging is automatically stopped.
To Next Page
Loading...