※ Do not turn off the power without stopping the logging. The logging data will be
damaged.
* To stop logging manually, press the CLEAR key.
* To automatically end logging faster when returning to the pit, set a shorter time.
* Be sure to stop logging when entering the pit.
7－－2: Logging the lap data from pit exit to pit return.
All lap data is logged from leaving the pit to returning the pit.
※ A SD memory card is required.
※ Speed measurement is required. Be aware that logging is not possible if the
speed is not measured.
１． There is a flashing hyphen or number on the right side of the parameter No.
Press the SET key and enter 2.
２．
Press the SHIFT key and move the flashing part to the wheel speed display, then
press the SET key and enter a number. When the set speed is reached, logging
is started.
３．
Next, press the SHIFT key and move the flashing part to the time display, then
press the SET key and enter a number. Logging is automatically stopped when
the length of time set here has passed after the wheel speed drops below the
speed set in 2.
４． Press the CLEAR key to move to the next parameter setting. To exit the setting,
press and hold the CLEAR key for 3 seconds.
Time setting
Vehicle speed setting
Parameter No.
To Next Page
Loading...