Percul Lapcom S Separate 100 - Page 39

Parameter No.
Sensor output
lower limit
Indicator
The indicato
r
mark is at the
bottom.
Press and hold the SE
T
key for 2 seconds when
the throttle is closed.
３． If calibration was completed correctly, the sensor output lower limit value is
determined automatically and the indicator mark moves to the top side.
４． Press and hold the SET key for 2 seconds when the throttle is fully opened.
５． If calibration was completed correctly, the sensor output upper limit value is
automatically determined, and the screen automatically changes to the next
setting screen (parameter No. 16).
-38-