Unpacking and Installation . 35
Unpacking the Spectrometer
WARNING
The spectrometer is a heavy precision instrument, so two people are
required for safe handling.
The instrument weighs approximately 34 kg unpacked (40 kg packed)
and has a lifting recess on either side. Consult the local codes of practice
issued by safety advisors before attempting to lift it.
Take care not to injure yourself or others, or to drop the instrument.
CAUTION
Take great care when installing your Frontier IR spectrometer, and
follow the procedures described in this manual. If you require assistance,
contact your local PerkinElmer Service Engineer.
Opening the shipping container
Your spectrometer is packed inside the box in a silver bag that protects it from condensation.
1. First remove the software box, leads, and so on from the box, and check that all the
following parts are present:
Part Number Description MIR NIR
L1202057 Polystyrene Calibration Film 1 –
L1180479 NIR Performance Validation Kit – 1
04974265 Quick Release Purge Coupling 2 2
L1200466 Ethernet Crossover Cable 1 1
04790839 2 A, 250 V Time Lag Fuse 2 2
09923433 8.0 mm Hexagonal Wrench 1 1
L1050002 IR & Raman Manuals CD 1 1
L1250230 Spectrum Configuration Disk 1 1
LX108873
OR
LX108875
Spectrum Standard Software Kit
OR
Spectrum ES Software Kit
1 1
L1240055 Cuvette Holder Assembly – 1
L1240056 Cell Holder Assembly & Disposable Cells (5) – 1
If any items are missing or damaged, contact your local PerkinElmer office.
To Next Page
Loading...
