Sewing
50
Program interrupt
Interrupts the seam program sequence, see chapter 10.03.03 Program interruption.
Roller presser up
When this function is activated, the roller presser is raised after sewing stops.
Roller presser down after thread trimming
When this function is activated, the roller presser is not raised after thread trimming.
Sewing is carried out using the pedal and knee switch functions, see chapter 7.04 Ped-
al.
If the knee switch should be used to switch between the seam zones, parame-
ter “201” must be set to “ON”. The switch-over between the seam zones can
only be made using the knee switch with this parameter setting.
To Next Page
Loading...
