Sewing
49
10.03 Programmed sewing
Pre-programmed seams can be called up via program numbers 3 - 49. All seam zones for
sewing in a sleeve are set in a seam program in programmed sewing mode. The informa-
tion on the seam program, such as the program number, the number of programmed seam
zones, the programmed comment and the ready-made size are displayed.
For easier orientation, a seam sketch of the armhole with the programmed seam zones is
shown. The seam start, seam end, the already processed seam zones, the current seam
zone and the seam zones still to be sewn are indicated by symbols and different line types
and line thicknesses. The respective seam zone number parameter, feed motion of the top
feed (roller presser) with fullness correction, feed motion of the bottom feed (feed wheel),
seam zone length are displayed for the current seam zone. The feed motion of the top feed
(roller presser) or the fullness correction can be changed directly.
Switch on the machine, select the desired program number from “3” to “49”, see chap-
ter 9.06 Selecting a program number.
Explanation of the displays and functions
Program selection
Opens the menu for inputting the program number, see chapter 9.06 Selecting a program
number.
Input mode
Quit the sewing mode and call up input mode.
Current seam zone
Displays the current seam zone.
Feed wheel stitch length
Displays the current value for the feed motion of the feed wheel
Seam zone length
Displays the current value for the seam zone length.
To Next Page
Loading...
Need help?
General
