Input
71
11.05 Error messages and description
Error Description
E 001 System error
E 002 Sewing motor E002/BB/xxx
BB = 20: Dead man
02: Position forwards
03: Position in reverse
05: Position by shortest route
09: Write parameters
10: Speed
0A: Reset stitch counter
0B: Stop after xxx stitches
30: Timeout for increasing speed
31: Timeout from uncertain positioning
32: Timeout from dead man command
33: Timeout for deleting errors
34: Timeout for emergency stop
35: Timeout for writing parameters
36: Timeout for resetting stitch counter
37: Timeout for stop command after x stitches
38: Timeout for initialisation
xxx = sewing motor control unit error byte (see motor errors)
E 003 Section
E 004 End of section
E 005 Pedal activated when machine turned on
E 006 Communication error with the stepping motor processor
E 007 End of ramp
E 008 Needle drive end position not found
E 009 Needle drive mid-point not found
E 010 Stepping motor processor error
E 011 Stepping motor step frequency too high
E 012 Sewing displacement error
E 013 Docu-seam system error
E 014 Incorrect program number (larger than 99)
E 015 Incorrect section number
E 016 Memory full
E 017 Incorrect stitch length
E 018 Unused
E 019 External control interface
E 020 Unused
E 021 Power supply unit overloaded (24V)
E 022 Mains voltage
E 023 Power supply 24V too low
E 024 CAN interface error
E 025 Unused
E 026 Unused
E 027 SD card error E27/xx
To Next Page
Loading...
Need help?
General
