Pfaff 1591

Input
60
In the fi rst seam zone
- the number of stitches should be 10 stitches
- the roller presser should work with a feed motion (stitch length) of 2.6 mm.
 Select the value 2.6 for the feed motion (stitch length) of the roller presser.
 Switch to the input of the second seam zone.
In the second seam zone
- the number of stitches should be 25 stitches
- the roller presser should work with a feed motion (stitch length) of 2.6 mm.
 Select the value 2.6 for the feed motion (stitch length) of the roller presser.
 Switch over to enter the second seam (left seam).
 Enter the seam zones of the left seam in the same way as the above-mentioned seam
zones.
 Activate the “End program” function.
 Conclude the input of the seam program and change to programmed sewing.