Adjustment
90
Group
Parameter
Description
User level
Setting range
Set value
6
668 Thread wiper / thread blower
1 = on; 0 = off
B,C 0 - 1 1
7 700 Needle position "0"
(needle reference position)
B,C 0 - 255 0
702 Needle position "1" (needle lowered) B,C 0 - 255 80
703 Needle position "2" (take-up lever raised) B,C 0 - 255 226
705 Needle position "5"
(magnetic thread trimming / end of cutting si-
gnal "1", start of tacting of cutting signal "1")
B,C 0 - 255 200
706 Needle position "6"
(pneumatic thread cutting / start of cutting
signal "2")
B,C 0 - 255 80
707 Needle position "9"
(start thread tension release / start thread
catcher)
B,C 0 -255 164
715 Switch on time for thread wiper [ms] B,C 0 - 2000 90
718 Stop brake tacting
0 = brake off
B,C 0 - 100 0
719 Tacting adjustment A4 (presser foot)
0 = 100 % power up
B,C 10 - 60 40
722 Acceleration ramp
1 = fl at; 50 = steep
B,C 1 - 60 50
723 Brake ramp
1 = fl at; 50 = steep
B,C 1 - 60 40
729 Start delay after lowering presser foot [ms] B,C 10 - 2000 150
730 Delay for raising presser foot after seam
end [ms]
B,C 0 - 2000 50
734 Tacting output A2 (thread trimming) B,C 10 - 60 40
760 No. of stitches for remaining thread after
response of bobbin thread monitor with
direct bobbin thread monitoring (with sensor)
Multiplier for the fi xed value "200" for deter-
mining initial value for stitch counter with in-
direct bobbin thread monitoring (with stitch
counting)
A,B,C 0 - 250 5
To Next Page
Loading...
