Adjustment
91
Group
Parameter
Description
User level
Setting range
Set value
7
761 Extension thread tension release / thread dra-
wing
B,C 0 - 80 0
770 Delay for raising pressure foot when pedal
set at "-1"
C 10 - 250 80
789 Needle position "10" (bearing position) B,C 0 - 255 239
797 Hardware test
1 = on; 0 = off
C 0 - 1 0
798 User lever "C"
1 = on; 0 = off
B,C 0 - 1 0
799 Selected machine class C 1 1
8 800 Motor rotation direction when looking at
V-belt pulley
1 = anti-clockwise; 0 = clockwise
C 0 - 1 0
801 Reversing angle at end of seam B,C 10 - 212 16
880 Max. starting power [A] C 1 - 30 10
884 Proportional sensitivity of the speed control
unit (general)
B,C 1 - 24 10
885 Integral sensitivity of the speed control unit C 10 - 80 50
886 Proportional sensitivity of the positioner C 1 - 15 8
887 Differential sensitivity of the positioner C 1 - 15 8
889 Time for positioning action
0 = always
C 0 - 2500 400
890 Proportional sensitivity of the superset positi-
oner for stop brake
C 1 - 25 15
897 MINI-motor variant
1 = long; 0 = short
C 0 - 1 0
898 No existing comment C 0 0
9 900 Additional P-sensitivity for speed control unit B,C 1 - 24 12
901 Cutting release - speed B,C 30 - 500 300
933 Switchover for display
1 = diagnosis; 0 = normal display
C 0 - 1 0
10 1000 Number of steppers B,C 0 - 1 1
1001 Starting angle of stepper B,C 0 - 255 110
1003 Feed roller radius C 5 - 50 11
To Next Page
Loading...
