2:2
123
Preparations
Unpacking
1. Place the box on a steady, fl at surface. Lift the
machine out of the box and remove the outer
packaging and lift off the machine carrying
case.
2. Remove all other packing material and the
plastic bag.
3. Slide off the accessory tray and remove the
styrofoam inside.
Note: Styrofoam left in the accessory tray while sewing
may affect stitch quality. The styrofoam is for packing
purposes only and should be removed.
Connect to the power supply
Among the accessories you will fi nd the power
cord and the foot control.
Note: Before plugging in the foot control, check to
ensure that it is type “FR5” (see underside of foot
control).
1. Pull out the cord from the foot control. Connect
the foot control cord to the front socket on the
bottom right side of the machine (1).
2. Connect the power cord to the rear socket on
the bottom right side of the machine (2). Plug
the cord into the wall socket.
3. Press the ON/OFF switch to ON to turn on
power and light (3).
For the USA and Canada
This sewing machine has a polarized plug (one
blade wider than the other). To reduce the risk
of electric shock, this plug is intended to fi t in a
polarized outlet only one way. If the plug does not
fi t fully in the outlet, reverse the plug. If it still does
not fi t, contact a qualifi ed electrician to install the
proper outlet. Do not modify the plug in any way.
Pack away after sewing
1. Switch the main switch (3) off.
2. Unplug the cord from the wall socket and then
from the machine (2).
3. Unplug the foot control cord from the machine
(1). Pull the cord gently and release - the cord
will retract itself into the foot control.
4. Place all accessories in the accessory tray. Slide
the tray on to the machine around the free arm.
5. Place the foot control in the space above the
free arm.
6. Put on the hard cover.
To Next Page
Loading...
Need help?
General
