9:7
11
12
Embroidery mode - stitch-out
Speed control (11)
This function enables you to easily reduce the
maximum embroidery speed. Just touch the speed
control icon to reduce the speed. To return to
normal speed, deselect the icon.
You can change the set speed limit. Long touch the
speed control icon to get a pop-up. Set the speed
limit you would like by sliding the button right
or left and then close the pop-up. The next time
you touch the speed control icon, the speed will be
reduced to the limit you have chosen.
You can embroider without closing the pop-up.
Note: If selecting the highest speed in the slider, it is like
choosing no speed limit at all. The icon in the option bar
will then be deselected and the speed limit will be set to
default.
Hoop position (12)
Use the hoop position functions to move the hoop
to different positions.
Current position
When you want to return to the current stitch and
start embroidering again where the embroidery
was interrupted, touch the current position icon.
You can also press the start/stop button once to
return to the current stitch and start to embroider.
Park position
When you have fi nished your embroidery, remove
the hoop and select park position. The embroidery
arm will be placed in a position that will allow easy
storage.
Use the park position when you need to have a free
sewing space with the embroidery arm out of the
way.
Note: It is very important that the hoop is removed,
otherwise it may be damaged.
Bobbin position
To make it easier to change the bobbin, touch
bobbin position. The hoop will move backwards,
allowing you to open the bobbin cover and replace
the bobbin.
Cut position
Cut position will move the hoop towards you
making it easier to cut jump stitches and trim fabric
when embroidering an appliqué.
Center position
Use the center position if you want to check where
the center position of the hoop will be placed on
the fabric.
To Next Page
Loading...
Need help?
General
