User Manual Philips MultiOne
© Philips Lighting B.V. 2014 Page 2 / 81
1 Introduction
Today’s customer demands more flexibility and customization possibilities than
“physical configurations” can offer. With new Philips configurable devices with built-in
controls or separate controllers you can configure the luminaire’s behavior. You can
control output levels, or even pre-configure dynamic dimming on the client’s request;
either directly in the factory or during installation on location. All you need is ONE
intuitive tool that when plugged into a device can calibrate ALL the different
functions required by any lighting solution.
Creating the perfect lighting solution has been made very easy with Philips MultiOne.
With MultiOne, you can configure all features that are supported by a Philips device.
A feature typically belongs to one or two product groups (LED Indoor/Outdoor, HID
or FLUO), but this does not mean that every device from a product group does
support all features.
Philips MultiOne is supported by Windows XP + SP3, Windows 7, Windows 8 and 8.1
operating systems. It works only in combination with the Philips LCN8600 MultiOne
interface USB2DALI, with Philips LCN8650 MultiOne interface USB2ZigBee or with
Philips LCN9600 MultiOne interface SimpleSet.
To Next Page
Loading...