For your safety
103503_en_03 PHOENIX CONTACT 1-5
1.5 Directives and standards
The manufacturers and operators of machines and systems, in which the PSR-TRISAFE-S
safety module is used, are responsible for adhering to all applicable directives and
legislation.
Directives and standards considered in the development and implementation of the
PSR-TRISAFE-S safety module:
Directives – Machinery Directive 2006/42/EC
– Machinery Directive 98/38/EC
– EMC Directive 2004/108/EC
– Low Voltage Directive 2006/95/EC
– Guideline for test and certification GS-ET-26: Bus systems for the transmission of
safety-related messages
Standards
Standard Contents
DIN EN 61508-1:11.2002
DIN EN 61508-2:12.2002
DIN EN 61508-3:12.2002
DIN EN 61508-4:11.2002
DIN EN 61508-5:11.2002
DIN EN 61508-6:06.2003
DIN EN 61508-7:06.2003
Functional safety of
electrical/electronic/programmable electronic safety-
related systems
DIN EN ISO 13849-1 Safety of machinery - Safety-related parts of control
systems; best suited for less complex systems.
Part 1: General principles for design
This standard was created on the basis of
EN 954-1:1996, quality management and reliability
aspects have been added.
DIN EN ISO 13849-2: 12.2003 Safety of machinery - Safety-related parts of control
systems - Part 2: Validation
EN ISO 12100-2 Safety of machinery - Basic concepts, general
principles for design
Part 2: Technical principles
DIN EN 62061
IEC 62061
Safety of machinery - Functional safety of electrical,
electronic and programmable control systems for
machinery.
Sector standard for machinery, created on the basis of
IEC 61508.
Safety for complex programmable systems.
Proof of safety of devices as well as evaluation of risk
reduction of the entire safety function through
calculation.
DIN EN 60204-1:11.1998 Safety of machinery - Electrical equipment of machines
- Part 1: General requirements
To Next Page
Loading...
Need help?
General
