2 Switching the seek mode
= For details, refer to this page.
3 Tuning in strong signals
= For details, refer to this page.
4 Switching the reception mode
= For details, refer to this page.
Storing the strongest broadcast
frequencies
“BSM” (best stations memory) lets you auto-
matically store the six strongest broadcast fre-
quencies under the preset tuning keys [P1]to
[P6] and, once stored there, you can tune in to
these frequencies with the touch of a key.
% Touch [Start] to turn BSM on.
BSM begins to flash. While BSM is flashing,
the six strongest broadcast frequencies will be
stored under the preset tuning keys [P1]to
[P6] in order of their signal strength. When
this is complete, BSM stops flashing.
p To cancel the storage process, touch
[Stop].
p Storing broadcast frequencies with BSM
may replace broadcast frequencies you
have already saved by using [P1]to[P6].
Switching the seek mode
You can select the method of seek tuning.
% Touch [Seek] to select the desired set-
ting.
! [All]:
Seeks stations from both analog and digital
broadcasting.
! [HD]:
Seeks from digital broadcasting only.
p If you select “HD” on this setting while
[Blending] is set to “Analog”, the setting
on [Blending] turns to “Digital-Analog
auto” automatically.
Tuning in strong signals
Local seek tuning allows you to tune in only
those radio stations with sufficiently strong
signals for good reception.
1 Touch [On] to turn local seek tuning on.
To turn local seek tuning off, touch [Off].
2 Touch [cPrev] or [Nextd] to set the sen-
sitivity.
There are four levels of sensitivity for FM and
two levels for AM:
FM: 1 — 2 — 3 — 4
AM: 1 — 2
p The FM “4” (AM “2”) setting allows recep-
tion of only the strongest stations, while
lower settings let you receive weaker sta-
tions.
Switching the reception mode
If a digital broadcast reception condition gets
poor, the tuner automatically switches to the
analog broadcast of the same frequency level
in default. If you want to prevent a frequent
automatic switching, switch this setting to
[Analog].
% Touch [Blending] to switch the recep-
tion mode.
! [Analog]:
Receives analog broadcasting only.
! [Digital-Analog auto]:
Automatically switches to the analog broad-
cast of the same frequency level as the digi-
tal broadcast.
p If you select “Analog” on this setting while
[Seek] is set to “HD”, the setting on [Seek]
turns to “All” automatically.
Using the HD Radio (Digital Radio)
En
105
Chapter
19
Using the HD Radio (Digital Radio)
To Next Page
Loading...
