You can listen to the radio by using this navi-
gation system. This section describes opera-
tions for radio (AM).
% Touch [AM] on the “AV Source” menu
to display the “AM” screen.
= For details concerning operations, refer to
Screen switching overview on page 18.
Reading the screen
5
4
123
1 Source icon
Shows which source has been selected.
2 Preset number indicator
Shows what preset item has been selected.
3 Frequency indicator
4 Signal level indicator
5 LOCAL indicator
Shows when local seek tuning is on.
Using the touch panel keys
12
3
4
5
1 Recalls equalizer curves
= For details, refer to Recalling equalizer
curves on page 140.
2 Displaying the “Function” menu
= For details, refer to Using the
“Function” menu on the next page.
3 Select a preset channel
c or d can be used to switch presets.
4 Perform manual tuning
To perform manual tuning, touch [c]or[d]
briefly. The frequencies move up or down one
step at a time.
Perform seek tuning
To perform seek tuning, keep touching [c]or
[d] for about one second and release. The
tuner will scan the frequencies until a broad-
cast strong enough for good reception is
found.
p You can cancel seek tuning by touching
either [c]or[d] briefly.
p If you keep touching [c]or[d], you can
skip broadcasting frequencies. Seek
tuning will start as soon as you release
the keys.
p Moving MULTI-CONTROL left or right
enables you to perform the equivalent
operations.
5 Displaying the map screen
Switching between the
detailed information display
and the preset list display
You can switch the left side of the basic screen
according to your preference.
% Touch [Preset] (or [Detail]).
Each touch of [Preset] (or [Detail]) changes
the detailed information display or preset list
display.
Using the radio (AM)
En
106
Chapter
20
To Next Page
Loading...
