Pioneer PDP-5000EX - Page 148

PDP-5000EX
148
1234
1234
C
D
F
A
B
E
Command Division Function
command
Reception Point
Last
Memory
Only
FAY is
Effective
Remarks
MST S00 FNC Single screen display
¶
S01 FNC PsideP (main size is normal)
¶
S08 FNC
SWAP (swapping pictures between the main screen and subscreen)
¶
Main
O
OSD S00 001 Turning OSD setting to off
¶
Main
S01 001 Turning OSD setting to off
¶
Main
P
PAV S∗∗ FNC Switching panel functions interlocked with the AV selection
¶
PBH ∗∗∗ ADJ Panel white balance adjustment - Blue highlight
¶
Mod
¶
UP/DW key not effective
PBL ∗∗∗ ADJ Panel white balance adjustment - Blue low light
¶
Mod
¶
UP/DW key not effective
PDM S00 FNC Passing PD signals to the Power SUPPLY Unit => Power-down
¶
S01 FNC Not passing PD signals to the Power SUPPLY Unit => No power-down
¶
PFN SGL (Panel) Factory mode: off
¶¶
PFS SGL Setup at shipment
¶¶
PFY SGL (Panel) Factory mode: on
¶¶
The MASK setting
and picture-quality
settings of the MB
remain the same.
PGH ∗∗∗ ADJ Panel white balance adjustment - Green highlight
¶
Mod
¶
UP/DW key not effective
PGL ∗∗∗ ADJ Panel white balance adjustment - Green low light
¶
Mod
¶
UP/DW key not effective
PGM 001 FNC Setting of the gamma table
¶
PMT S00 FNC Canceling panel muting
¶
S01 FNC Panel muting
¶
POF SGL Power off
¶¶
Main
PON SGL Power on
¶¶
Main
PPT S00 FNC Panel protection: off
¶¶
S01 FNC Panel protection: on
¶¶
PRH ∗∗∗ ADJ Panel white balance adjustment - Red highlight
¶
Mod
¶
UP/DW key not effective
PRL ∗∗∗ ADJ Panel white balance adjustment - Red low light
¶
Mod
¶
UP/DW key not effective
PUC S00 FNC Pure cinema: off
¶¶
Main
¶
S01 FNC Pure cinema: standard
¶¶
Main
¶
S02 FNC Pure cinema: advanced
¶¶
Main
¶
Q
QAJ QST Acquiring various adjustment values
¶
QIP QST Acquiring various input signal data
¶
QMT QST Acquiring temperature of MTB side and Fan speed
¶
QNG QST Acquiring shut-down information of MTB side
¶
QPD QST Acquiring logs of power-down points
¶
QPM QST Acquiring data of the pulse meter
¶
QPW QST Acquiring panel white balance adjustment values
¶
QS1 QST
Acquiring unit data, such as the software version common to all models,
regardless of destination
¶¶
QS2 QST Acquiring data on the status of the unit, such as temperature
¶
QSD QST Acquiring data on shutdown
¶
QSI QST Acquiring data related with signals of panel side
¶
Mod Main