Pitney Bowes mailstation - Setting Sleep Mode Activation Time

1. PressMenu.
2. PressReview (down)toscrolltoChange setup?.
3. PressEnter/Yes.
4. PressReview (down)toscrolltoUse lock code setup?.
5. PressEnter/Yes.
6. Ifalockcodehasbeenestablished,themeterpromptsyoutoenterthelockcodeatthispoint.
Enterthefour-digitcode.
7. PressEnter/yes.
8. PressReview (down)toscrolltoTurn On Lock Code.
9. PressEnter/YesattheSet A Lock Code?prompt.
10. Enterafour-digitcode.
11. PressEnter/Yes.
12. Enterthesamecodeagaintoconfirm.Amessageconfirmsyourchoice.
13. PressNowhenaskedtoStay in Setup?toreturntotheHomescreen.
Oncealockcodeisset,presstheLockbuttontolockthescreen.
Related article
l
Disabling your lock code
Setting Sleep Mode Activation Time
Youcansettheamountoftimethemachinewaitsuntilentering"sleepmode".Whenthemachineisin
sleepmode,thedisplayisblank(exceptforthetimeinthelowerright)andyoucannotprocessmail.
Toawakenthemachine,simplypressanybuttononthecontrolpanel.
NOTE:Ifyouhaveenabledthelockcodeoption,youmustenterthelockcodetoawakenthemachine.
1. PressMenu.
2. UsetheReviewkeystoscrollto"Changesetup"andpressEnter/ yes.
3. UsetheReviewkeystoscrollto"Changesleeptimeout?"andpressEnter/yes.
4. Keyinthedesiredamountoftime(inminutes,from1-20)themachineshouldbeidlebeforethe
sleepmodeactivatesandpressEnter/yes.Amessageconfirmsyourchoices.
5. Whenpromptedtostayinsetup,pressNotoreturntothemainscreen.
Configuring Your Mailing Machine
Pitney Bowes Operator Guide January 2024 47