Industrial Renewable Energy 4-Port 10/100/1000T
802.3at PoE+ Managed Ethernet Switch/Router
BSP-360
31
2.2.3 Wall Mount Plate Mounting
To install the Renewable Energy Switch on the wall, please follow the instructions below.
Follow all the DIN-rail installation steps as shown in the example.
Step 1: Remove the DIN-rail from the Renewable Energy Switch. Use the screwdriver to loosen the screws to
remove the DIN-rail.
Step 2: Place the wall-mount plate on the rear panel of the Renewable Energy Switch.
Step 3: Use the screwdriver to screw the wall mount plate on the Renewable Energy Switch.
Step 4: Use the hook holes at the corners of the wall mount plate to hang the Renewable Energy Switch on
the wall.
Step 5: To remove the wall mount plate, reverse the steps above.
To Next Page
Loading...
