User Manual of WDAP-C1750
-62-
The page includes the following fields:
Object Description
Administrator Name Set the access point’s administrator name. This is used to log in to the
browser based configuration interface.
Administrator
Password
Set the access point’s administrator password. This is used to log in to
the browser based configuration interface.
Product Name Edit the product name according to your preference. This name is used
for reference purposes.
Management Protocol Check/uncheck the boxes to enable/disable specified management
interfaces (see below). When SNMP is enabled, complete the SNMP
fields below.
SNMP Version Select SNMP version appropriate for your SNMP manager.
SNMP Get Community Enter an SNMP Get Community name for verification with the SNMP
manager for SNMP-GET requests.
SNMP Set Community Enter an SNMP Set Community name for verification with the SNMP
manager for SNMP-SET requests.
SNMP Trap Enable or disable SNMP Trap to notify SNMP manager of network
errors.
SNMP Trap
Community
Enter an SNMP Trap Community name for verification with the SNMP
manager for SNMP-TRAP requests.
SNMP Trap Manager Specify the IP address or sever name (maximum 128 characters) of the
SNMP manager.
HTTP: Internet browser HTTP protocol management interface
HTTPS: Internet browser HTTPS protocol management interface
TELNET: Client terminal with Telnet protocol management interface
SSH: Client terminal with SSH protocol version 1 or 2 management interface
SNMP: Network management protocol. SNMPv1, v2 & v3 protocol supported. SNMPv2 can be used
with community based authentication. SNMPv3 uses user-based security model (UM) architecture.
FTPD: Third-party FTP server.
SNMP: Third-party TFTP server.
To Next Page
Loading...
Need help?
General
