User Manual of WDAP-C1750
-52-
5.3.9 WPS
Wi-Fi Protected Setup (WPS) is a simple way to establish connections between WPS compatible devices.
WPS can be activated on compatible devices by pushing a WPS button on the device or from within the device’s
firmware/configuration interface (known as PBC or “Push Button Configuration”).
When WPS is activated in the correct manner and at the correct time for two compatible devices, they will
automatically connect. “PIN code WPS” is a variation of PBC which includes the additional use of a PIN code
between the two devices for verification.
Figure 5-25 WPS
The page includes the following fields:
Object Description
WPS
Check/uncheck this box to enable/disable WPS functionality.
WPS must be disabled when using MAC-RADIUS authentication
Product PIN
Displays the WPS PIN code of the device, used for PIN code WPS. You will be
required to enter this PIN code into another WPS device for PIN code WPS.
Click “Generate PIN” to generate a new WPS PIN code.
Push-button
WPS
Click “Start” to activate WPS on the access point for approximately 2 minutes.
This has the same effect as physically pushing the access point’s WPS button.
WPS by PIN
Enter the PIN code of another WPS device and click “Start” to attempt to
establish a WPS connection for approximately 2 minutes.
WPS Status
WPS security status is displayed here. Click “Release” to clear the existing
status.
To Next Page
Loading...
Need help?
General
