Planet WDAP-C1750 - Basic Settings

User Manual of WDAP-C1750
-22-
4.3 Basic Settings
The instructions below will help you to configure the following basic settings of the access point:
 LAN IP Address
 2.4GHz & 5GHz SSID & Security
 Administrator Name & Password
 Time & Date
It is recommended you configure these settings before using Planet WDAP-C1750.
4.3.1 LAN IP Address
1. To change the access point’s LAN IP address, go to “Network Settings” > “LAN-side IP Address” and you will
see the screen below.
Figure 4-7 Basic Settings - DHCP
2. Enter the IP address settings you want to use for your access point. You can use a dynamic (DHCP) or static
IP address, depending on your network environment. Click “Apply” to save the changes and wait a few moments
for the access point to reload.
When you change your access point’s IP address, you need to use the new IP address to
access the browser based configuration interface instead of the default IP 192.168.1.253.