Planet WDAP-C1750 - Time & Date; Figure 4-10 Basic Settings - Time & Date

User Manual of WDAP-C1750
-24-
4.3.4 Time & Date
1. To set the correct time for your access point, go to “Management” > “Date and Time”.
Figure 4-10 Basic Settings - Time & Date
2. Set the correct time and time zone for your access point using the drop down menus. The access point also
supports NTP (Network Time Protocol) so alternatively you can enter the host name or IP address of a time
server. Click “Apply” when you are finished.
You can also use the “Acquire Current Time from your PC” button if you wish to set the access point to the
same time as your PC.