Planmeca ProOne - Switching Between Normal and Practice Modes

14 SETTINGS
78 Planmeca ProOne User’s Manual
•Mode
Normal mode: Touch the
Normal mode field to switch
normal operating mode on. When normal mode is in use
the
Normal mode field is shown highlighted.
Practice mode: Practice mode enables you to practice/
demonstrate program functions available on your X-ray
unit. In practice mode no radiation is generated when you
press the exposure button and there is no connection to a
computer. The C-arm will move normally but no radiation
will be generated and no radiation warning signals will be
given, i.e. this is a “dummy run” function for training and
demonstration purposes. For example, you might want to
demonstrate the C-arm movements before taking
exposures of children or nervous patients.
Touch the
Practice mode field to switch practice mode on.
When practice mode is in use the
Practice mode field is
shown highlighted and symbols indicating that radiation
and PC connection are disabled will appear in the status
bar on all displays.
To switch practice mode off, touch the
Normal mode field.
Accept your selection by touching the green check mark
button in the bottom right corner of the display. To exit the
display without saving the changes, touch the red cross
button in the bottom left corner of the display.
No PC connection
No radiation