5.10
BODY / STEERING / SUSPENSION
SEAT / HEAD REST
Seat Back / Head Rests
1. Fasten the seat back to the rear cab frame(s) using the Torx-head screws. NOTE: For seats that have staples visible from
the rear, the seat back cover will need to be placed between the rear cab frame and seat back assembly. Tighten all Torx-
head fasteners to 18-20 in. lbs. (2-2.5 Nm).
2. Install the headrests on the cab frame using 1/4”-20 x 1” bolts, washers, and 1/4”-20 Nyloc nuts. Place the washers between
the bolt heads and headrest as shown below. Torque bolts to 10 in. lbs. (1.1 Nm).
3. Check all screws and fasteners for proper torque and installation.
To Next Page
Loading...
