9.28
BRAKES
REAR CALIPER SERVICE (4X4 CREW)
Rear Caliper Exploded View
Caliper Removal
1. Elevate and safely support the rear of the vehicle.
2. Remove the (4) wheel nuts, (4) washers and rear wheel.
3. Clean caliper area before removal.
4. Place a container below the caliper to catch brake fluid
when removing the line. Remove brake line from caliper.
5. Loosen brake pad adjustment set screw 2-3 turns to allow
brake pad removal after the caliper is removed.
A. Socket Set Screw
B. Bleeder Screw
C. Caliper Assy.
D. Boot
E. Square O-rings
F. Piston
G. Ca l ip e r M o u nt
H. Brake Pads
A
B
C
D
E
F
G
H
Apply Polaris All Purpose
Grease
Apply Polaris DOT 4 Brake Fluid
to Component
47 in. lbs.
(5.3 Nm)
E
CAUTION
Use care when supporting vehicle so that it does not
tip or fall. Severe injury may occur.
Remove
Brake Line
Pad
Adjuster
To Next Page
Loading...
Need help?
General
