2.13
MAINTENANCE
2
NOTE: Apply a small amount of general purpose
grease to the sealing edges of the filter before
installing.
2. Check air box. If oil or water deposits are found, drain them
into a suitable container.
NOTE: Service more frequently if vehicle is operated
in wet conditions or at high throttle openings for
extended periods.
3. Install air box cover and secure with clips.
Air Intake Inspection
1. Lift the hood.
2. Inspect the foam insert in the engine intake air baffle box.
If the foam insert is dirty, clean the foam with a high flash
point solvent, followed by hot soapy water.
3. Rinse and dry the foam thoroughly.
4. Inspect the foam for tears or damage. Replace if necessary.
5. Reinstall the foam insert into the air baffle box.
NOTE: The PVT intake air baffle box
does NOT have a foam insert.
Foam
Air Baffing
Box
Engine Intake Duct
Air Box
PVT Intake Duct
To Next Page
Loading...
