6.22
CLUTCHING
10. Inspect the Teflon™ coating on the moveable sheave
bearings.
11. Inspect driven clutch sheave faces for wear or damage.
12. Clean and inspect splines on helix and transmission input
shaft.
13. Lube splines with a light film of grease. Do not lubricate
the bearings!
Clutch Assembly
1. Install the inner spring retainer if removed. Do not apply
oil or grease to the bearings.
2. Align the “X” marks on each of the sheaves during
reassembly.
3. Install spring into inner retainer.
4. Install outer retainer on top of spring.
5. Place the clutch into Clutch Compression Tool PN
8700220. Using Compression Extensions PN PS-45909,
apply and hold downward pressure on the outer spring
retainer. Carefully install the snap ring.
6. Compress the outer retainer and install the snap ring.
Assemble Sheaves
Snap Ring
To Next Page
Loading...
