Polaris 2009 RANGER 700 - MID Drive Exploded View; MID Drive Shaft (6 X6); Removal; Disassembly; Assembly

7.27
FINAL DRIVE
7
Mid Drive Exploded View
MID DRIVE SHAFT (6X6)
Removal
1. Repeat Steps 1-7 in the “Mid Drive Hub / Bearing Carrier
Removal” section.
2. Slide the middle axle out of the bearing carrier by pulling
the bearing carrier assembly outward and down.
3. Pull the middle axle straight out from the frame. The axle
will slide off the mid gearcase splined output shaft.
Disassembly / Assembly
NOTE: For mid drive shaft service information, see
“REAR DRIVE SHAFT (4X4 CREW) - CV Joint / Boot
Replacement”
BUSHING
MID UPPER A-ARM
BEARING CARRIER
BEARING
SNAP RING
HUB
MID LOWER A-ARM
SHAFT
MID DRIVE AXLE
BUSHING
BUSHING
35 ft. lbs.
(47 Nm)
35 ft. lbs.
(47 Nm)
35 ft. lbs.
(47 Nm)
35 ft. lbs.
(47 Nm)
SHAFT