9.25
BRAKES
9
REAR CALIPER SERVICE (6X6)
Rear Caliper Exploded View
Caliper Removal
1. Safely support the rear of the machine.
2. Use a wrench to remove the brake line. Place a container
to catch brake fluid draining from brake lines.
3. After the fluid has drained into the container, remove the
two caliper mounting bolts and remove caliper.
4. Clean disc, caliper body, and pistons with brake cleaner or
alcohol.
A. Socket Set Screw
B. Bleeder Screw
C. Caliper Assy.
D. Boot
E. Square O-rings
F. Piston
G. Ca l ip e r M o u nt
H. Brake Pads
A
B
C
D
E
F
G
H
Apply Polaris All Purpose
Grease
Apply Polaris DOT 4 Brake Fluid
to Component
47 in. lbs.
(5.3 Nm)
E
CAUTION
Use care when supporting vehicle so that it does
not tip or fall. Severe injury may occur
if machine tips or falls.
Remove Banjo Bolt
Remove Caliper Bolts
To Next Page
Loading...
