Polaris Hawkeye - Pod;Key Switch;Choke;Speedo Connection Removal;Installation; Steering; Handlebar Removal

5.8
BODY AND STEERING
POD/KEY SWITCH/CHOKE/SPEEDO CONNECTION REMOVAL/INSTALLATION
1. Remove the plastic dart clips(1) from the pod (2).
2. Press the center and pull the speedo connection away from the speedo (3).
3. Remove the key switch connection by turning the ignition nut (9) counter clock wise.
4. Remove the choke connection by turing the choke nut (14) counterclockwise.
5. Remove the choke cable (13) from the pod.
6. Replace in reverse order of removal.
STEERING
HANDLEBAR REMOVAL
1. Remove the handlebar pod. See “POD/KEY SWITCH/CHOKE/SPEEDO CONNECTION REMOVAL/INSTALLATION”
on page 5.8.
2. Remove the handlebar block fasteners and (A) the mounting bracket (B).
3. Remove the handlebar assembly from the steering post.
A
B