Polaris Hawkeye - Ball Joint; Replacement; Rear Suspension

5.15
BODY AND STEERING
BALL JOINT
REPLACEMENT
1. Remove the A-Arm. See “A-ARM REMOVAL” on
page 5.13.
2. Remove the snap ring (1) from the ball joint.
3. Press out the old ball joint (2).
4. Press in new ball joint into A-Arm.
5. Replace the snap ring (1) onto the new ball joint.
6. Assemble the A-Arm, See “A-ARM ASSEMBLY” on
page 5.13.
REAR SUSPENSION
1
2