7.26
FINAL DRIVE
8. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and the
shaft. This will allow the air pressure to equalize in the
CV boot in the position that the joint will spend most of its
life. Before you remove your instrument, be sure the
small end of the boot is in its correct location on the axle.
CARE MUST BE TAKEN TO AVOID DAMAGE TO
THE NEWLY INSTALLED BOOT.
9. Install the small clamp on the boot.
To Next Page
Loading...
