User Guide for the Polycom SoundStation IP 7000 Phone
1 - 10
• Audio connectors and ports on the Multi-Interface Module—to connect
wireless (lapel) microphones, speakers, and recording devices and
computers (to record phone calls).
To connect audio components to the Multi-Interface Module, see your
system administrator.
After you connect an auxiliary audio component to the Multi-Interface
Module, you must enable the component. To enable the component, see
Enabling Auxiliary Audio Components on page 2-12.
2.5mm Audio Connector on Phone
Your conference phone has a 2.5mm audio connector to connect to a mobile
phone or to a computer calling application. You connect a mobile phone or
computer calling application so you can use the conference phone speaker to
stream two-way audio from the mobile phone or computer calling application
for hands-free conversations. When you connect mobile or computer audio to
your conference phone, all participants in a call or conference call (including
those connected through a mobile phone or computer calling application) can
hear and speak to each other.
The 2.5mm audio connector is located on the right side of your conference
phone, behind a door you flip open.
The following figure shows the 2.5mm audio connector on the side of the
conference phone. The 2.5mm audio connector has a mobile phone icon above
it.
Note
You do not have to enable audio from a mobile phone or from a computer calling
application. This audio is automatically enabled when you connect the
Mobile Phone Cable or the Computer Calling Cable to the 2.5mm audio connector
on your conference phone.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
