39
Power Tip: How to Quickly Set
Up a Conference
If your phone has an active call and one held call—on the same or a
dierent line—press More and then Join from either Lines or Calls
view to automatically create a conference call. The conference call
takes place on the line from which you handled the last active call.
When you place a conference call on hold, you place the other two people in the call on
hold. No one in a held conference call can hear each other. To hold just one person, see
Managing Conference Call Participants.
Holding and Resuming Conference Calls
From Lines or Calls view, press Hold. If you’re in Calls
view, be sure to highlight the conference first. The other
two people in the conference are held. The following
example shows a held conference in Calls view.
To place a conference call on hold :
From Lines or Calls view, press Resume.
To resume a held conference call :
To end a conference, and your connection to the other people, press End Call. By default,
when you press End Call, the other two people remain connected. However, your system
administrator may have set up your phone so that all connections end.
Ending Conference Calls
From Lines or Calls view, press End Call.
To end a conference call :
To Next Page
Loading...
