76
From the PTT Channel Configuration screen, press Accept While Busy, and enable
or disable the setting. The default setting is Disabled. When enabled, your phone will
accept and play broadcasts while you’re in an active call. When disabled, your phone
won’t play broadcasts while you’re in a call, but will hold them as
Pending
instead.
2
Group Paging Mode
Your phone may be enabled to operate in a broadcast mode called Group Paging mode.
In this mode, you can broadcast one-way announcements to a specified group of phones,
called a Paging Group. In Group Paging mode, users must subscribe to Paging Groups to
send and receive pages.
Sending and Receiving Pages
To send and receive pages, you need to subscribe to certain paging groups. By default, you’re
subscribed to Paging Groups 1, 24, and 25. This means that you can send and receive pages
to Paging Groups 1, 24, and 25.
Sending Pages
By default, when you send a group page, it’s automatically sent to Paging Group 1. This is
your default paging group.
You can change your default paging group to any group you want (see Updating the Default
Paging Group). If you change your default paging group, you’re automatically subscribed to it.
You can’t send a Page-mode page while you’re in an active call.
From Lines view, press Paging and hold.
From the Paging Groups List screen, select the paging group to send the page to.
To begin a page, press Page.
Just before the page starts, you’ll hear an alert tone, and then the page begins.
Begin speaking.
To end the page, press End Page.
To send a page :
1
2
3
4
5
To Next Page
Loading...
